Connect HELLA ONYX to Zubie and unlock powerful automations

This trigger fires every time a vehicle arrives at a specific place such as Home or Work (defined within Zubie).

This trigger fires when the wind peak value is above or below the defined threshold.

This Trigger fires every time a vehicle leaves a place.

This trigger fires when the sun brightness is above or below the defined threshold.

This Trigger fires every time a vehicle starts a trip, indicated by the ignition being turned on.

This Trigger fires at the end of every vehicle trip, as indicated by the Ignition being turned off.

This Trigger fires when ANY vehicle's Check Engine light has been activated, caused by a Diagnostic Trouble Code (DTC).

This Trigger fires when battery levels fall below normal levels for any vehicle in your account. The vehicle ingredient specifies the name of the vehicle with the problem.

This Trigger fires when a vehicle trip ends during a selected time frame.

This Triggers when your vehicle is further than an allowed distance from a specific location.

This Trigger fires when a trip is completed that is longer than a specified distance.

Triggers when a vehicle detects a hard brake event.

Triggers when your vehicle has a hard-acceleration event.

Triggers when your vehicle is driven at speeds above a safe level (configured within Zubie).

This query returns a list of the end of every vehicle trip, as indicated by the Ignition being turned off.

This query returns a list of when your vehicle was a hard-acceleration event.

This query returns a list of when a vehicle trip ends during a selected time frame.

This query returns a list of when ANY vehicle's Check Engine light was been activated, caused by a Diagnostic Trouble Code (DTC).

This query returns a list of when your vehicle was further than an allowed distance from a specified location.

This query returns a list of instances when a vehicle left a place.

This query returns a list of when a vehicle arrived at a specific place such as Home or Work (defined within Zubie).

This action will move the blinds (device or group) to the defined position and angle.

This action will turn the selected devices on/off or set the defined brightness.