When temperature drops below a certain point, start emergency heating
Start today
Other popular BlueLink Smart Connect workflows and automations
- Turn on Cooling and Text Me When Outside Temp Rises
- When pressing a button, turn off the system and fan
- Turn on the fan for one hour
- Decrease the heating temperature of your home during on-peak hours
- Precool your home before on-peak hours start
- If the temperature outside rise above a chosen point, set the cool to chosen temperature
- Increase the cooling temperature of your home during on-peak hours
- Preheat your home before on-peak hours start
Useful BlueLink Smart Connect and Honeywell Total Connect Comfort integrations
Triggers (If this)
- System Mode ChangeThis trigger fires when the system mode changes
- Room Temperature Drops BelowThis trigger fires when the temperature in the room drops below the chosen temperature
- Room Temperature Rises AboveThis trigger fires when the temperature in the room rise above the chosen temperature
- Room Humidity Drops BelowThis trigger fires when the humidity in the room drops below the specified percentage
- Room Humidity Rises AboveThis trigger fires when the humidity in the room rises above the specified percentage
- Fan Mode ChangeThis trigger fires when fan mode is changed to the specified value
- Hold Status ChangeThis trigger fires when the hold status of the device is changed to the specified value
- Set Temperature Changes To Above XThis trigger fires when you set the setpoint of either heat or cool to a temperature above a threshold specified by you
- Set Temperature Changes To Below XThis trigger fires when you set the setpoint of either heat or cool to a temperature below a threshold specified by you
- Low Remote Sensor BatteryThis trigger fires when the remote sensor battery is low
- Low Thermostat BatteryThis trigger fires when the thermostat battery is low
- Check WarningThis trigger fires when the check warning activates
- UV WarningThis trigger fires when the UV warning activates
- HUMID PADS WarningThis trigger fires when the HUMID PADS warning activates
- Filter WarningThis trigger fires when the filter warning activates
Queries (With)
Actions (Then that)
- Change Room TemperatureThis action will change the current room temperature. Will either HEAT or COOL, based on what temperature is the thermostat is showing.
- Set temperature to a permanent holdThis Action will set your Honeywell thermostat to permanently hold the specified temperature until you change it.
- Change Cool SetpointThis action will change the current cool setpoint of the selected device.
- Set temperature for a period of timeThis Action will set your Honeywell thermostat to hold a temperature for a specified period of time. The schedule will resume when the time expires.
- Change Heat SetpointThis action will change the current heat setpoint of the selected device.
- Resume programmed scheduleThis Action will set your Honeywell thermostat to resume the currently defined thermostat programmed schedule.
- Change Hold StatusThis action will change the current hold status of the device (either ENABLED or DISABLED)
- Set fan to on or autoThis Action will set the Honeywell thermostat fan to On where the fan is always on or Auto where the fan runs only when the heating or cooling system is on.
- Change System ModeThis action will change the current running mode of the device
- Change Fan ModeThis action will change the current fan mode of the device
- Change Hold ModeThis action will change the current hold mode of the device
IFTTT helps all your apps and devices work better together