Connect BlueLink Smart Connect to iOS Photos and unlock powerful automations

This trigger fires when the system mode changes

This Trigger fires every time a new photo is added to your camera roll.

This trigger fires when the temperature in the room drops below the chosen temperature

This Trigger fires every time you take a screenshot.

This trigger fires when the temperature in the room rise above the chosen temperature

This Trigger fires every time you take a photo in an area you specify.

This trigger fires when the humidity in the room drops below the specified percentage

This Trigger fires every time you take a photo with the front camera.

This trigger fires when the humidity in the room rises above the specified percentage

This Trigger fires every time you take a photo with the rear camera.

This trigger fires when fan mode is changed to the specified value

This Trigger fires every time a new photo is added to the album you specify.

This trigger fires when the hold status of the device is changed to the specified value

This trigger fires when you set the setpoint of either heat or cool to a temperature above a threshold specified by you

This trigger fires when you set the setpoint of either heat or cool to a temperature below a threshold specified by you

This trigger fires when the remote sensor battery is low

This trigger fires when the thermostat battery is low

This trigger fires when the check warning activates

This trigger fires when the UV warning activates

This trigger fires when the HUMID PADS warning activates

This trigger fires when the filter warning activates

This query returns the current state of the selected device

This query returns validated interval for on-peak hours

This action will change the current room temperature. Will either HEAT or COOL, based on what temperature is the thermostat is showing.

This Action will save a new photo to the album you specify.

This action will change the current cool setpoint of the selected device.

This action will change the current heat setpoint of the selected device.

This action will change the current hold status of the device (either ENABLED or DISABLED)

This action will change the current running mode of the device

This action will change the current fan mode of the device

This action will change the current hold mode of the device