Connect RainMachine to Telldus Live! and unlock powerful automations

This Trigger fires every time a zone has started.

This trigger fires every time your device is switched on.

This Trigger fires every time a zone has stopped.

This trigger fires every time your device is switched off.

This Trigger fires every time a watering program has started.

This trigger fires every time the temperature rises above the chosen value.

This Trigger fires every time a watering program has stopped.

This trigger fires every time the temperature drops below the chosen value.

This Trigger fires every time device disconnects from the remote access service.

This trigger fires every time the humidity rises above the chosen value.

This Trigger fires when device connects to the remote access service.

This trigger fires every time the humidity drops below the chosen value.

This Trigger fires every time a new software update is available.

This trigger fires every time the power rises above the chosen value.

This Trigger fires when freeze protect mode is in effect.

This trigger fires every time the power level drops below the chosen value.

This Trigger fires every time the rain sensor detects rain.

This trigger fires every time the luminance rises above the chosen value.

This Trigger fires every time the rain sensor finished to detect rain.

This trigger fires every time the luminance drops below the chosen value.

This Trigger fires every time weather did not update for 24h

This Trigger fires every time a new weather update was successfully executed.

This Trigger fires every time a leak was detected by your sprinkler

This Trigger fires every time a reboot has occurred during watering zone or program

This Trigger fires every time an automatic firmware update has occurred.

This Trigger fires every time a snooze has become inactive.

This Trigger fires every time a snooze has become active.

This query returns a list of when your device was switched off.

This query returns a list of when the rain sensor detects rain.

This query returns a list of events when your device was switched on.

This query returns a list of when the watering program started.

This query returns a list of times the temperature drops below the chosen value. Note: this query will only return future events after this Applet is created.

This query returns a list of when device connected to the remote access service.

This query returns a list of when the luminance drops below the chosen value. Note: this query will only return future events after this Applet is created.

This query returns a list of every time a new software update is available.

This query returns a list of when the temperature rose above the chosen value. Note: this query will only return future events after this Applet is created.

This Action will start watering a specific zone for a certain period of time.

Turn off a device that support switching off.

This Action will run a specific watering program.

Turn on a device that support switching on.

This action will schedule a program to start in the next minute. The difference between scheduling a program to start and just starting a program is that scheduled program will take weather into account whereas a started program will always water 100% of the set duration

Dim a device that support dimming.

This Action will cancel all running watering events.

Send up to a device that support up. It may be e.g. Blinds or a Projector screen

This Action will skip all watering events for a certain period of time.

Send down to a device that support up. It may be e.g. Blinds or a Projector screen

This Action will enable a specific program

Send bell to a device that supports a bell. E.g. a door bell.

This Action will disable a specific program

This action will change the start time for a specific program.

This action will resume all watering and require beta firmware.

This Action will pause all running watering events and require beta firmware.

This action will save weather data. Make sure you have enabled Local Weather Push from Weather > Developer > Local Weather Push. The units for the data should be metric units.

This action will change the stop time for a specific program.