Connect beam to GraspIO and unlock powerful automations

This trigger fires when the Analog Sensor value matches the specified condition.

This trigger fires when the selected door state (open, closed) for a garage door you have access to is achieved.

This trigger fires when the Digital Sensor value matches the specified condition.

This action will run a project saved in your GraspIO Studio account.

This action will ask the controller to close the garage door you specify. If the garage door is already closed, then the door will remain closed.

This action will display text on the OLED.

This action will ask the controller to open the garage door you specify. If the garage door is already open, then the door will remain open.

This action will turn on the RGB LED with the selected color.

This action will ask the controller to partially open the garage door you specify. If the garage door is already partially open, then the door will remain partially open.

This action will alternately display two colors for the selected duration/delay on the LED .

This action will make the board speak using the interfaced Speaker.

This action will capture a photo or GIF using the interfaced camera.

This action will control the Servo Motor angle and speed.

This action will control the Digital Output ports on the board.

This action will beep the buzzer by turning it on and off at the desired frequency.