Change device brightness on a schedule
Start today
Other popular Epion workflows and automations
- Log high CO₂ levels in Google Sheets
- Change light color when measured CO₂ rises above 1000 ppm
- Automatically run WeMo humidifier when humidity is low
- Play alert on Spotify when the CO₂ level is very high
- Turn off your FIBARO connected ventilator when the CO₂ level dips above a certain level
- Turn off Philips Hue connected ventilator when the CO₂ level dips above a certain level
- Turn on your FIBARO connected ventilator when the CO₂ level rises above a certain level
- Turn on your Hue connected ventilator when the CO₂ level rises above a certain level
Useful Epion and GraspIO integrations
Triggers (If this)
- CO₂ above a specified valueThis trigger fires when the CO₂ level for a specific devices exceeded a specified threshold.
- Trigger when Analog Sensor firesThis trigger fires when the Analog Sensor value matches the specified condition.
- CO₂ below a specified valueThis trigger fires when the CO₂ level for a specific devices becomes lower than the specified threshold.
- Trigger when Digital Sensor firesThis trigger fires when the Digital Sensor value matches the specified condition.
- Temperature above a specified valueThis trigger fires when the temperature for a specific device exceeds the specified threshold.
- Temperature below a specified valueThis trigger fires when the temperature for a specific device becomes lower than the specified threshold.
- Humidity below a specified valueThis trigger fires when the humidity for a specific device becomes lower than the specified threshold.
- Humidity above a specified valueThis trigger fires when the humidity for a specific device becomes higher than the specified threshold.
Queries (With)
Actions (Then that)
- Run a projectThis action will run a project saved in your GraspIO Studio account.
- Set brightnessThis action will update the LED brightness for a specific device
- Display text on OLED screenThis action will display text on the OLED.
- Control RGB LEDThis action will turn on the RGB LED with the selected color.
- Flash RGB LEDThis action will alternately display two colors for the selected duration/delay on the LED .
- Speak the entered textThis action will make the board speak using the interfaced Speaker.
- Capture a photo or GIFThis action will capture a photo or GIF using the interfaced camera.
- Control Servo MotorThis action will control the Servo Motor angle and speed.
- Control Digital Output portsThis action will control the Digital Output ports on the board.
- Beep BuzzerThis action will beep the buzzer by turning it on and off at the desired frequency.
IFTTT helps all your apps and devices work better together