This trigger fires if irrigation for an irrigation area has started

This trigger fires whenever a leak is detected

This trigger fires if irrigation has stopped for given irrigation area

This trigger fires whenever the controller detects the pipe is dry.

This trigger fires if soil is dry for given irrigation area compared to your moisture borders

This trigger fires whenever the freeze setpoint is hit.

This trigger fires if soil is wet enough for given irrigation area compared to your moisture borders

This query returns a list of when irrigation for an area has started.

This query returns a list of when soil was dry for given irrigation area compared to your moisture borders

This query returns a list of if irrigation was stopped for given irrigation area

This action will start irrigation for the given irrigation area.

This action will reset the alarm state on the controller

This action will stop irrigation for the given irrigation area.

This action will trip the leak alarm on the leak detector.

This action will activate automatic irrigation for the given irrigation area.

This action will allow you to change the schedule mode on the leak detector.

This action will deactivate automatic irrigation for given irrigation area until it is activated again. E.g. if you have a garden party you can deactivate sprinklers using this action.

This action will allow you to manually open and close the valve on the leak detector.

This action will notify MIYO if it is raining or not. This action can be used to integrate existing rain sensors into your irrigation system.

This action will check and install updates to your cube.

The irrigation should not start as long as the automower is still mowing. To handle this situation, MIYO can be informed if the automower has started or finished mowing.