Connect GraspIO to MobiLinc and unlock powerful automations

This trigger fires when a lock changes status.

This trigger fires when the Analog Sensor value matches the specified condition.

This trigger fires when an INSTEON or Z-Wave device turns on or off.

This trigger fires when the Digital Sensor value matches the specified condition.

This trigger fires when a state or integer variable is set.

This trigger fires when a security area changed state to armed or disarmed.

This trigger fires when a program is true or false.

This trigger fires when a Motion, Water Leak, TriggerLinc, or Door sensor turns on or off.

This trigger fires when any Z-Wave device is reporting 20% or less battery remaining.

This query returns a list of when a lock changes status.

This query returns a list of when an INSTEON or Z-Wave device turns on or off.

This action will enable, disable, or run a program's If, Then, or Else condition.

This action will run a project saved in your GraspIO Studio account.

This action will turn an INSTEON or Z-Wave light on, off, or dim.

This action will display text on the OLED.

This action will lock or unlock a Z-Wave lock.

This action will turn on the RGB LED with the selected color.

This action will turn a scene on or off.

This action will alternately display two colors for the selected duration/delay on the LED .

This action will set a state or integer variable to a custom value.

This action will make the board speak using the interfaced Speaker.

This action will arm or disarm a security area.

This action will capture a photo or GIF using the interfaced camera.

This action will adjust a thermostat's mode and setpoint.

This action will control the Servo Motor angle and speed.

This action will open or close the garage door controlled by an INSTEON IOLinc.

This action will control the Digital Output ports on the board.

This action will turn an INSTEON, Z-Wave, or X10 device on or off.

This action will beep the buzzer by turning it on and off at the desired frequency.