Connect GraspIO to Nuki Opener and unlock powerful automations

This trigger fires every time someone unknown rings the doorbell connected to the Opener.

This trigger fires when the Analog Sensor value matches the specified condition.

This trigger fires every time someone directly opens a door with the Nuki Opener.

This trigger fires when the Digital Sensor value matches the specified condition.

This trigger fires every time someone opens a door using Ring to Open.

This trigger fires every time someone unlocks the door with Auto Unlock.

This trigger fires every week, if the battery state of the Nuki Opener is critical.

This query returns a list of events when the doorbell connected to the Opener was ringed by someone else.

This query returns a list of when someone unlocks the door with Auto Unlock.

This query returns a list of every week, if the battery state of the Nuki Opener was critical.

This action will run a project saved in your GraspIO Studio account.

This action will open the door with the Nuki Opener.

This action will display text on the OLED.

This action will activate Ring to Open which will open the door automatically when somebody rings the doorbell in a preset timeframe.

This action will turn on the RGB LED with the selected color.

This action will deactivate Ring to Open.

This action will alternately display two colors for the selected duration/delay on the LED .

This action will activate Ring to Open in Continuous Mode, i.e. permanently until it is deactivated again.

This action will make the board speak using the interfaced Speaker.

This action will deactivate the Continuous Mode for Ring to Open.

This action will capture a photo or GIF using the interfaced camera.

This action will control the Servo Motor angle and speed.

This action will control the Digital Output ports on the board.

This action will beep the buzzer by turning it on and off at the desired frequency.