Connect GraspIO to WeMo Insight Switch and unlock powerful automations

This Trigger fires every time your WeMo Insight Switch is turned on.

This trigger fires when the Analog Sensor value matches the specified condition.

This Trigger fires every time your WeMo Insight Switch is turned off.

This trigger fires when the Digital Sensor value matches the specified condition.

This Trigger fires every time your WeMo Insight Switch enters standby mode. The switch enters standby mode when the device attached to it is manually powered off or stops drawing power.

This Trigger fires when the device attached to your WeMo Insight Switch is turned on longer than the minutes you specify.

This Trigger fires when the cost of the device attached to your WeMo Insight Switch rises above the daily value you specify.

This Trigger fires when the estimated cost of the device attached to your WeMo Insight Switch rises above the value you specify.

This query returns a list of times when your WeMo Insight Switch entered standby mode. The switch enters standby mode when the device attached to it was manually powered off or stops drawing power.

This query returns a list of times when your WeMo Insight Switch was turned off.

This query returns a list of when your WeMo Insight Switch was turned on.

This query returns a list of when the WeMo Insight Switch was turned on longer than the specified minutes.

This action will run a project saved in your GraspIO Studio account.

This Action will turn a WeMo Insight Switch on. If the WeMo Insight Switch is already on, it will remain on.

This action will display text on the OLED.

This Action will turn a WeMo Switch off. If the WeMo Switch is already off, it will remain off.

This action will turn on the RGB LED with the selected color.

This Action will turn a WeMo Insight Switch on then immediately back off.

This action will alternately display two colors for the selected duration/delay on the LED .

This Action will turn a WeMo Switch off then immediately back on.

This action will make the board speak using the interfaced Speaker.

This Action will toggle a WeMo Insight Switch on or off.

This action will capture a photo or GIF using the interfaced camera.

This action will control the Servo Motor angle and speed.

This action will control the Digital Output ports on the board.

This action will beep the buzzer by turning it on and off at the desired frequency.