Connect Heatmiser to Zynect Sensors and unlock powerful automations

This Trigger fires every time the temperature rises above a threshold you specify.

This trigger fires when a sensor's value is below a specified value.

This Trigger fires every time the temperature drops above a threshold you specify.

This trigger fires when a sensor's value is above a specified value.

This trigger fires when your neoHub is set to away mode.

This trigger fires when a sensor's value is out of bounds.

Triggers when your neoHub returns to Home Mode.

This trigger fires when the sensor battery is low.

This trigger fires when your Heatmiser Device has a Low Battery.

This trigger fires when a threshold sensor detects an active condition (e.g. a leak sensor detects water).

This trigger fires when the Contact Sensor is closed

This trigger fires when a threhsold sensor no longer detects an active condition (e.g. a leak sensor no longer detects water).

This trigger fires when the Contact Sensor is opened

This query returns data the sensor has measured.

This Action will cancel a temperature hold on the selected Heatmiser Thermostat.

This Action will enable a temperature hold on the selected Heatmiser Thermostat.

This Action will allow you to switch on the selected neoPlug.

This Action will turn off the selected neoPlug.

The Action will set the temperature on the selected Heatmiser Thermostat.

This Action will activate a Timer Boost on the selected Heatmiser Timer.

This Action will activate Away Mode on your neoHub

The Action will activate Home Mode on your neoHub.

This Action will activate Standby Mode on the selected Heatmiser Thermostat.

This Action will cancel Standby Mode on the selected Heatmiser Thermostat.

This action will send a stored profile to the selected thermostat.

This action will run a Heatmiser Neo recipe.