Connect HomeSeer to RainMachine and unlock powerful automations

This Trigger fires every time a zone has started.

This Trigger fires when a device attached to your HomeSeer system is turned on.

This Trigger fires every time a zone has stopped.

This Trigger fires when a device attached to your HomeSeer system is turned off.

This Trigger fires every time a watering program has started.

This Trigger fires every time a watering program has stopped.

This Trigger fires every time device disconnects from the remote access service.

This Trigger fires when device connects to the remote access service.

This Trigger fires every time a new software update is available.

This Trigger fires when freeze protect mode is in effect.

This Trigger fires every time the rain sensor detects rain.

This Trigger fires every time the rain sensor finished to detect rain.

This Trigger fires every time weather did not update for 24h

This Trigger fires every time a new weather update was successfully executed.

This Trigger fires every time a leak was detected by your sprinkler

This Trigger fires every time a reboot has occurred during watering zone or program

This Trigger fires every time an automatic firmware update has occurred.

This Trigger fires every time a snooze has become inactive.

This Trigger fires every time a snooze has become active.

This query returns a list of when the rain sensor detects rain.

This query returns a list of when a device attached to your HomeSeer system was turned on.

This query returns a list of when the watering program started.

This query returns a list of when device connected to the remote access service.

This query returns a list of every time a new software update is available.

This Action will run a HomeSeer system event. HomeSeer events can be programmed to control just about any combination of home automation products installed in your home!

This Action will start watering a specific zone for a certain period of time.

This Action will turn on a device attached to your HomeSeer system. Devices may include light switches, receptacles, plug-in modules and much more!

This Action will run a specific watering program.

This Action will turn off a device attached to your HomeSeer system. Devices may include light switches, receptacles, plug-in modules and much more!

This action will schedule a program to start in the next minute. The difference between scheduling a program to start and just starting a program is that scheduled program will take weather into account whereas a started program will always water 100% of the set duration

This Action will dim a dimmable lighting device attached to your HomeSeer system.

This Action will cancel all running watering events.

This Action will lock a door lock attached to your HomeSeer system.

This Action will skip all watering events for a certain period of time.

This Action will unlock a door lock attached to your HomeSeer system.

This Action will enable a specific program

This Action will change the cool set-point of a thermostat attached to your HomeSeer system.

This Action will disable a specific program

This Action will change the heat set-point of a thermostat attached to your HomeSeer system.

This action will change the start time for a specific program.

This Action will change the the operating mode of a thermostat attached to your HomeSeer system to auto.

This action will resume all watering and require beta firmware.

This Action will change the the operating mode of a thermostat attached to your HomeSeer system to off.

This Action will pause all running watering events and require beta firmware.

This Action will change the the operating mode of a thermostat attached to your HomeSeer system to cool.

This action will save weather data. Make sure you have enabled Local Weather Push from Weather > Developer > Local Weather Push. The units for the data should be metric units.

This Action will change the the operating mode of a thermostat attached to your HomeSeer system to heat.

This action will change the stop time for a specific program.

This action will send a text command to your HomeSeer system.