Increase the cooling temperature of your home during on-peak hours
Start today
Other popular BlueLink Smart Connect workflows and automations
-
- If the temperature outside drops below a chosen point, set the heat to chosen temperature
- When pressing a button, turn off the system and fan
1 - When temperature drops below a certain point, start emergency heating
- If the temperature outside rise above a chosen point, set the cool to chosen temperature
- Decrease the heating temperature of your home during on-peak hours
- Precool your home before on-peak hours start
- Every day at a certain time, modify the temperature in the room
- Preheat your home before on-peak hours start
Useful BlueLink Smart Connect and GraspIO integrations
Triggers (If this)
- System Mode ChangeThis trigger fires when the system mode changes
Trigger when Analog Sensor firesThis trigger fires when the Analog Sensor value matches the specified condition.- Room Temperature Drops BelowThis trigger fires when the temperature in the room drops below the chosen temperature
- Trigger when Digital Sensor firesThis trigger fires when the Digital Sensor value matches the specified condition.
- Room Temperature Rises AboveThis trigger fires when the temperature in the room rise above the chosen temperature
- Room Humidity Drops BelowThis trigger fires when the humidity in the room drops below the specified percentage
- Room Humidity Rises AboveThis trigger fires when the humidity in the room rises above the specified percentage
- Fan Mode ChangeThis trigger fires when fan mode is changed to the specified value
- Hold Status ChangeThis trigger fires when the hold status of the device is changed to the specified value
- Set Temperature Changes To Above XThis trigger fires when you set the setpoint of either heat or cool to a temperature above a threshold specified by you
- Set Temperature Changes To Below XThis trigger fires when you set the setpoint of either heat or cool to a temperature below a threshold specified by you
- Low Remote Sensor BatteryThis trigger fires when the remote sensor battery is low
- Low Thermostat BatteryThis trigger fires when the thermostat battery is low
- Check WarningThis trigger fires when the check warning activates
- UV WarningThis trigger fires when the UV warning activates
- HUMID PADS WarningThis trigger fires when the HUMID PADS warning activates
- Filter WarningThis trigger fires when the filter warning activates
Queries (With)
Actions (Then that)
- Run a projectThis action will run a project saved in your GraspIO Studio account.
- Change Room TemperatureThis action will change the current room temperature. Will either HEAT or COOL, based on what temperature is the thermostat is showing.
- Display text on OLED screenThis action will display text on the OLED.
- Change Cool SetpointThis action will change the current cool setpoint of the selected device.
- Control RGB LEDThis action will turn on the RGB LED with the selected color.
- Change Heat SetpointThis action will change the current heat setpoint of the selected device.
- Flash RGB LEDThis action will alternately display two colors for the selected duration/delay on the LED .
- Change Hold StatusThis action will change the current hold status of the device (either ENABLED or DISABLED)
- Speak the entered textThis action will make the board speak using the interfaced Speaker.
- Change System ModeThis action will change the current running mode of the device
- Capture a photo or GIFThis action will capture a photo or GIF using the interfaced camera.
- Change Fan ModeThis action will change the current fan mode of the device
- Control Servo MotorThis action will control the Servo Motor angle and speed.
- Change Hold ModeThis action will change the current hold mode of the device
- Control Digital Output portsThis action will control the Digital Output ports on the board.
- Beep BuzzerThis action will beep the buzzer by turning it on and off at the desired frequency.
IFTTT helps all your apps and devices work better together