Connect GraspIO to Home Connect Washer and unlock powerful automations

This trigger fires every time your washer cycle starts.

This trigger fires when the Analog Sensor value matches the specified condition.

This trigger fires every time your washer cycle is complete.

This trigger fires when the Digital Sensor value matches the specified condition.

This trigger fires every time your washer door has been opened (works only if the washer is turned on).

This trigger fires every time your washer door has been closed (works only if the washer is turned on).

This trigger fires every time i-Dos content 1 is low. Please note that this trigger is not supported by all washers.

This trigger fires every time i-Dos content 2 is low. Please note that this trigger is not supported by all washers.

This query returns a list of when your washer cycle was complete.

This query returns a list of when your washer door was opened (works only if the washer was turned on).

This query returns a list of when your washer cycle was started.

This action will run a project saved in your GraspIO Studio account.

This action will start the selected washer program with your preferred settings.

This action will display text on the OLED.

This action will start the washer program that is currently selected on the appliance.

This action will turn on the RGB LED with the selected color.

This action will stop the active washer program.

This action will alternately display two colors for the selected duration/delay on the LED .

This action will pause the active washer program.

This action will make the board speak using the interfaced Speaker.

This action will resume the paused washer program.

This action will capture a photo or GIF using the interfaced camera.

This action will turn off your washer.

This action will control the Servo Motor angle and speed.

This action will control the Digital Output ports on the board.

This action will beep the buzzer by turning it on and off at the desired frequency.