Connect GraspIO to Honeywell evohome and unlock powerful automations

This trigger fires when the Analog Sensor value matches the specified condition.

This trigger fires when the Digital Sensor value matches the specified condition.

This action will run a project saved in your GraspIO Studio account.

This Action will turn the hot water at one of your locations on. This can either be permanent or for a number of hours.

This action will display text on the OLED.

This Action will turn the hot water at one of your locations off. This can either be permanent or for a number of hours.

This action will turn on the RGB LED with the selected color.

This Action will enable a quick action at one of your locations. This can either be permanent or for a number of days/hours.

This action will alternately display two colors for the selected duration/delay on the LED .

This Action will remove any existing quick action at your location and set your heating system to follow the schedule.

This action will make the board speak using the interfaced Speaker.

This Action sets an override on target temperature of one of your zones. This can either be permanently set or just for a number of hours.

This action will capture a photo or GIF using the interfaced camera.

This action will control the Servo Motor angle and speed.

This action will control the Digital Output ports on the board.

This action will beep the buzzer by turning it on and off at the desired frequency.