Connect GraspIO to Webhooks and unlock powerful automations

This trigger fires every time the Maker service receives a web request to notify it of an event. For information on triggering events, go to your Maker service settings and then the listed URL (web) or tap your username (mobile)

This trigger fires when the Analog Sensor value matches the specified condition.

This trigger fires every time the Maker service receives a web request to notify it of an event. For information on triggering events, go to your Maker service settings and then the listed URL (web) or tap your username (mobile)

This trigger fires when the Digital Sensor value matches the specified condition.

This query returns the status code from a request made to the provided URL. If the response body is in the correct format it will also return the body’s extracted values. Please see the documentation link on the Webhooks service page.

This query returns the JSON response body. You can use filter code to parse it. Please see the documentation link on the Webhooks service page.

This query returns a list of times when the Maker service received a web request to notify it of an event. For information on querying events, go to your Maker service settings and then the listed URL (web) or tap your username (mobile)

This action will run a project saved in your GraspIO Studio account.

This action will make a web request to a publicly accessible URL. NOTE: Requests may be rate limited.

This action will display text on the OLED.

This action will turn on the RGB LED with the selected color.

This action will alternately display two colors for the selected duration/delay on the LED .

This action will make the board speak using the interfaced Speaker.

This action will capture a photo or GIF using the interfaced camera.

This action will control the Servo Motor angle and speed.

This action will control the Digital Output ports on the board.

This action will beep the buzzer by turning it on and off at the desired frequency.