Connect GraspIO to MIYO and unlock powerful automations

This trigger fires if irrigation for an irrigation area has started

This trigger fires when the Analog Sensor value matches the specified condition.

This trigger fires if irrigation has stopped for given irrigation area

This trigger fires when the Digital Sensor value matches the specified condition.

This trigger fires if soil is dry for given irrigation area compared to your moisture borders

This trigger fires if soil is wet enough for given irrigation area compared to your moisture borders

This query returns a list of when irrigation for an area has started.

This query returns a list of when soil was dry for given irrigation area compared to your moisture borders

This query returns a list of if irrigation was stopped for given irrigation area

This action will run a project saved in your GraspIO Studio account.

This action will start irrigation for the given irrigation area.

This action will display text on the OLED.

This action will stop irrigation for the given irrigation area.

This action will turn on the RGB LED with the selected color.

This action will activate automatic irrigation for the given irrigation area.

This action will alternately display two colors for the selected duration/delay on the LED .

This action will deactivate automatic irrigation for given irrigation area until it is activated again. E.g. if you have a garden party you can deactivate sprinklers using this action.

This action will make the board speak using the interfaced Speaker.

This action will notify MIYO if it is raining or not. This action can be used to integrate existing rain sensors into your irrigation system.

This action will capture a photo or GIF using the interfaced camera.

This action will check and install updates to your cube.

This action will control the Servo Motor angle and speed.

The irrigation should not start as long as the automower is still mowing. To handle this situation, MIYO can be informed if the automower has started or finished mowing.

This action will control the Digital Output ports on the board.

This action will beep the buzzer by turning it on and off at the desired frequency.