Connect GraspIO to RescueTime and unlock powerful automations

This Trigger fires when a new daily summary becomes available (usually at midnight in your local timezone).

This trigger fires when the Analog Sensor value matches the specified condition.

This Trigger fires every time a RescueTime alert goes off.

This trigger fires when the Digital Sensor value matches the specified condition.

This Trigger fires every time you add a new highlight event in RescueTime.

This Trigger fires every time a FocusTime session is started.

This Trigger fires at the end of a Focus Time session.

This Trigger fires when a new weekly summary becomes available (usually at midnight in your local timezone).

This query returns a list of every time a RescueTime alert goes off.

The query returns a list of events when FocusTime session was started.

This query returns a list of when a new weekly summary becomes available (usually at midnight in your local timezone).

This query returns a list of when a new daily summary becomes available (usually at midnight in your local timezone).

This query returns a list of every time you add a new highlight event in RescueTime.

This action will run a project saved in your GraspIO Studio account.

This Action will create a new highlight or action log entry. Highlight events show up as a list of accomplishments in your reports. Action events are similar, but they can be grouped and categorized as well.

This action will display text on the OLED.

This Action will start a FocusTime session in RescueTime.

This action will turn on the RGB LED with the selected color.

This Action will cancel an active FocusTime session in RescueTime. If there is not an active FocusTime session, it will do nothing.

This action will alternately display two colors for the selected duration/delay on the LED .

This Action will log offline time to your RescueTime account.

This action will make the board speak using the interfaced Speaker.

This action will capture a photo or GIF using the interfaced camera.

This action will control the Servo Motor angle and speed.

This action will control the Digital Output ports on the board.

This action will beep the buzzer by turning it on and off at the desired frequency.