This Trigger fires every time a zone has started.

This trigger fires when your Hubitat device closes.

This Trigger fires every time a zone has stopped.

This trigger fires when your Hubitat device opens.

This Trigger fires every time a watering program has started.

This trigger fires when your Hubitat device turns off.

This Trigger fires every time a watering program has stopped.

This trigger fires when your Hubitat device turns on.

This Trigger fires every time device disconnects from the remote access service.

This trigger fires when the Hubitat mode changes.

This Trigger fires when device connects to the remote access service.

This trigger fires when new motion is detected.

This Trigger fires every time a new software update is available.

This trigger fires when motion is no longer detected.

This Trigger fires when freeze protect mode is in effect.

This trigger fires every time your Hubitat device's presence is detected.

This Trigger fires every time the rain sensor detects rain.

This trigger fires every time your Hubitat device's presence is no longer detected.

This Trigger fires every time the rain sensor finished to detect rain.

This trigger fires every time the temperature drops below the specified threshold.

This Trigger fires every time weather did not update for 24h

This trigger fires every time the temperature rises above the specified threshold.

This Trigger fires every time a new weather update was successfully executed.

This trigger fires every time your Hubitat device detects water.

This Trigger fires every time a leak was detected by your sprinkler

This trigger fires every time your Hubitat device no longer detects water.

This Trigger fires every time a reboot has occurred during watering zone or program

This Trigger fires every time an automatic firmware update has occurred.

This Trigger fires every time a snooze has become inactive.

This Trigger fires every time a snooze has become active.

This query returns a list of recent times when your Habitat device opened.

This query returns a list of when the rain sensor detects rain.

This query returns a list of when the Hubitat mode has changed.

This query returns a list of when the watering program started.

This query returns a list of when your Hubitat device turned off.

This query returns a list of when device connected to the remote access service.

This query returns a list of recent Hubitat device turns on events.

This query returns a list of every time a new software update is available.

This query returns a list of when the temperature rises above the specified threshold. Note: this query will only return future events after this Applet is created.

This Action will start watering a specific zone for a certain period of time.

This action will change Hubitat's mode.

This Action will run a specific watering program.

This action will close a Hubitat device.

This action will schedule a program to start in the next minute. The difference between scheduling a program to start and just starting a program is that scheduled program will take weather into account whereas a started program will always water 100% of the set duration

This action will change a device's dimmer level.

This Action will cancel all running watering events.

This action will lock a Hubitat device.

This Action will skip all watering events for a certain period of time.

This action will open a Hubitat device.

This Action will enable a specific program

This action will turn off your Hubitat switches, lights, sirens, strobes, etc.

This Action will disable a specific program

This Action will turn on a device attached to your Hubitat Elevation system.

This action will change the start time for a specific program.

This action will unlock a Hubitat device.

This action will resume all watering and require beta firmware.

This Action will pause all running watering events and require beta firmware.

This action will save weather data. Make sure you have enabled Local Weather Push from Weather > Developer > Local Weather Push. The units for the data should be metric units.

This action will change the stop time for a specific program.