Connect RainMachine to Scout Alarm and unlock powerful automations

This Trigger fires every time a zone has started.

This Trigger fires when a mode is armed.

This Trigger fires every time a zone has stopped.

This Trigger fires when a mode is disarmed.

This Trigger fires every time a watering program has started.

This Trigger fires when the alarm for a specific mode is triggered.

This Trigger fires every time a watering program has stopped.

This Trigger fires when the alarm for a specific mode is dismissed.

This Trigger fires every time device disconnects from the remote access service.

This Trigger fires when any or a specific door panel is opened.

This Trigger fires when device connects to the remote access service.

This Trigger fires when any or a specific door panel is closed.

This Trigger fires every time a new software update is available.

This Trigger fires when any or a specific access sensor is opened.

This Trigger fires when freeze protect mode is in effect.

This Trigger fires when any or a specific access sensor is closed.

This Trigger fires every time the rain sensor detects rain.

This Trigger fires when any or a specific motion sensor detects motion. Your Scout system must be in an Armed state.

This Trigger fires every time the rain sensor finished to detect rain.

This Trigger fires every time weather did not update for 24h

This Trigger fires every time a new weather update was successfully executed.

This Trigger fires every time a leak was detected by your sprinkler

This Trigger fires every time a reboot has occurred during watering zone or program

This Trigger fires every time an automatic firmware update has occurred.

This Trigger fires every time a snooze has become inactive.

This Trigger fires every time a snooze has become active.

This query returns a list of when any or a specific access sensor was closed.

This query returns a list of when the rain sensor detects rain.

This query returns a list of when a mode was armed.

This query returns a list of when the watering program started.

This query returns a list of when any or a specific door panel was closed.

This query returns a list of when device connected to the remote access service.

This query returns times when a mode was disarmed.

This query returns a list of every time a new software update is available.

This query returns a list of when the alarm for a specific mode was dismissed.

This query returns a list of times when any or a specific door panel was opened.

This query returns a list of times when the alarm for a specific mode was triggered.

This query returns a list of times when any or a specific access sensor was opened.

This query returns a list of when any or a specific motion sensor detected motion while your Scout system was in an Armed state.

This Action will start watering a specific zone for a certain period of time.

This Action will arm a mode at your location of choice (home, vacation home, etc).

This Action will run a specific watering program.

This Action will disarm a mode at your location of choice (home, vacation home, etc).

This action will schedule a program to start in the next minute. The difference between scheduling a program to start and just starting a program is that scheduled program will take weather into account whereas a started program will always water 100% of the set duration

This Action will disarm any mode at your location that is in arming or armed mode.

This Action will cancel all running watering events.

This Action will turn on the siren in the Scout Hub and Scout Door Panels (if you have any).

This Action will skip all watering events for a certain period of time.

This Action will turn off the siren in the Scout Hub and Scout Door Panels (if you have any).

This Action will enable a specific program

This Action will make the hub chirp.

This Action will disable a specific program

This Action will enable a key fob at your location of choice.

This action will change the start time for a specific program.

This Action will disable a key fob at your location of choice.

This action will resume all watering and require beta firmware.

This Action will pause all running watering events and require beta firmware.

This action will save weather data. Make sure you have enabled Local Weather Push from Weather > Developer > Local Weather Push. The units for the data should be metric units.

This action will change the stop time for a specific program.