Connect RainMachine to SkylinkNet and unlock powerful automations

This Trigger fires every time a zone has started.

This Trigger fires when the hub is in a specific state.

This Trigger fires every time a zone has stopped.

This Trigger fires when the sensor battery is low.

This Trigger fires every time a watering program has started.

This Trigger fires when a sensor has been activated.

This Trigger fires every time a watering program has stopped.

This Trigger fires when a sensor returns to normal.

This Trigger fires every time device disconnects from the remote access service.

This Trigger fires when a switch is turned on (SkylinkNet compatible 2-way switch).

This Trigger fires when device connects to the remote access service.

This Trigger fires when a switch has been turned off. (SkylinkNet compatible 2-way switch)

This Trigger fires every time a new software update is available.

This Trigger fires when a garage door (with SkylinkNet Hub) is opened.

This Trigger fires when freeze protect mode is in effect.

This Trigger fires when a garage door (with SkylinkNet Hub) is closed.

This Trigger fires every time the rain sensor detects rain.

This Trigger fires when an Orbit garage door is opened.

This Trigger fires every time the rain sensor finished to detect rain.

This Trigger fires when an Orbit garage door is closed(with Orbit Home App).

This Trigger fires every time weather did not update for 24h

This Trigger fires every time a new weather update was successfully executed.

This Trigger fires every time a leak was detected by your sprinkler

This Trigger fires every time a reboot has occurred during watering zone or program

This Trigger fires every time an automatic firmware update has occurred.

This Trigger fires every time a snooze has become inactive.

This Trigger fires every time a snooze has become active.

This query returns a list of times when a sensor was activated.

This query returns a list of when the rain sensor detects rain.

This query returns a list of events when the hub was in a specific state.

This query returns a list of when the watering program started.

This query returns a list of when an Orbit garage door was opened (with Orbit App)

This query returns a list of when device connected to the remote access service.

This query returns a list of when a sensor returned to normal.

This query returns a list of every time a new software update is available.

This Action will start watering a specific zone for a certain period of time.

This Action will set the hub to a specific mode.

This Action will run a specific watering program.

This Action will turn on the selected device.

This action will schedule a program to start in the next minute. The difference between scheduling a program to start and just starting a program is that scheduled program will take weather into account whereas a started program will always water 100% of the set duration

This Action will turn off the selected device.

This Action will cancel all running watering events.

This Action will toggle the selected device.

This Action will skip all watering events for a certain period of time.

This Action will open your Skylink garage door (with SkylinkNet Hub).

This Action will enable a specific program

This Action will close your Skylink garage door (with SkylinkNet Hub).

This Action will disable a specific program

This Action will toggle your Skylink garage door (with SkylinkNet Hub).

This action will change the start time for a specific program.

This action will close your Skylink Orbit garage door.

This action will resume all watering and require beta firmware.

This Action will turn on the Orbit garage light.

This Action will pause all running watering events and require beta firmware.

This Action will turn off the Orbit garage Light.

This action will save weather data. Make sure you have enabled Local Weather Push from Weather > Developer > Local Weather Push. The units for the data should be metric units.

This action will change the stop time for a specific program.