Connect Ambi Climate to go-e Charger and unlock powerful automations

This trigger fires when charging has started.

This Trigger fires when the air conditioner has been turned on or off.

This trigger fires when the car is plugged in.

This Trigger fires when your device detects the temperature is below the threshold you specified.

This trigger fires when an Error occurs.

This Trigger fires when your device detects the temperature is above the threshold you specified.

This trigger fires when the charging process has finished.

This Trigger fires when your device detects the humidity is below the threshold you specified.

This trigger fires when charging is paused.

This trigger fires when your device detects the humidity is above the threshold you specified.

This trigger fires when the model status changes.

This trigger fires when a transaction happened.

This query returns the amount of power from your battery.

This query returns a list of when your device detected the humidity was above the threshold you specified. Note: this query will only return future events after this Applet is created.

This query returns the ssid of the currently connected WiFi.

This query returns a list of when your device detects the temperature was below the threshold you specified. Note: this query will only return future events after this Applet is created.

This query returns the friendly name of the charger.

This query returns a list of when your device detected that the temperature was above the threshold you specified. Note: this query will only return future events after this Applet is created.

This query returns the variant of the charger.

This query returns the current charger mode.

This query returns the grid frequency.

This query returns the automatic stop energy limit.

This query returns the flexible energy tariff price limit.

This query returns the current card id.

This query returns the total energy charged since purchase.

This query returns the temperature of the connector (type 2) and power supply.

This query returns true if an current limiting adapter (i.e. 16A) is used.

This query returns the load balancing amperes.

This query returns the force state.

This query returns the energy limit for the current charging session.

This query returns the IP address of the charger.

This query returns the firmware version.

This query returns the energy array.

This query returns the colors for Idle, Charging and Done.

This query returns the cable current limit.

This query returns the current model status.

This query returns the effective charging current.

This query returns the amount of power delivered by your pv.

This query returns the current unlock mode.

This query returns the requested current.

This query returns information about a connected WiFi.

This query returns the car state (Unknown, Idle, Wait for Car, Charging, Finished or Error).

This query returns the current state of access control setting.

This query returns the led-ring brightness

This query returns true/false, depending on if the car is allowed to charge right now.

This query returns the amount of power delivered by the power grid.

This query returns the led energy save mode.

This action will set the charging current.

This Action will turn off your A/C in the specified room.

This action will pause the charging process.

This Action will turn on your A/C in the specified room, and run it in Comfort mode.

This action will start the charging process.

This Action will turn on your A/C in the specified room, and run it in Away mode.

This action will set the charging state to Neutral, Force-Off or Force-On.

This Action will provide Comfort feedback for the device that you specified.

This action will reboot the charger.

This Action will turn on your A/C in the specified room, and run it in Temperature mode.

This action will set the energy limit for the current charging session.

This action will set the mode of the charger.

This action will set the ledring brightness.

This action will set the friendly name.

This action will set the colors for Idle, Charging and Done.

This action will set the unlock mode.

This action will set the access control setting.

This action will set the transaction setting.

This action will set the led energy save mode.

This action will set the flexible energy tariff price limit.

This action will set the automatic stop energy.