Connect domovea to GraspIO and unlock powerful automations

This Trigger fires every time your device is switched on.

This trigger fires when the Analog Sensor value matches the specified condition.

This Trigger fires every time your device is switched off.

This trigger fires when the Digital Sensor value matches the specified condition.

This Trigger fires every time your Security system is armed.

This Trigger fires every time your security system is disarmed.

This Trigger fires every time an intrusion is detected by your security system.

This Trigger fires every time your device detects room temperature above the value you specified.

This Trigger fires every time your device detects indoor temperature below the value you specified.

This Trigger fires every time your shades are opened.

This Trigger fires every time your shades are closed.

This Trigger fires every time your thermostat reaches the temperature you specified.

This Trigger fires every time a scene is launched.

This Trigger fires every time the wind speed is equal to the value you specified.

This Trigger fires every time when the CO2 is equal to the ppm you specified.

This Trigger fires every time when the indoor humidity is equal to the percentage you specified.

This Trigger fires every time when the luminosity is equal to the value you specified.

This Trigger fires every time when the brightness is equal to the value you specified.

This Trigger fires every time when it is raining.

This Trigger fires every time when the outdoor temperature is equal to the value you specified.

This Trigger fires every time when the indoor temperature is equal to the value you specified.

This Trigger fires every time when the outdoor humidity is equal to the percentage you specified.

This Trigger fires every time when the smoke alarm goes off.

This query returns a list of recent times when the outdoor temperature was at a specified value in celcius.

This query returns a list of when CO2 is recorded at a specified ppm.

This query returns a list of when your security system was disarmed.

This query returns a list of when your shades are opened.

This query returns a list of when your device detected indoor temperature to be below the value that you specified. Note: this query will only return future events after this Applet is created.

This query returns a list of recent alerts when the brightness was equal to the value you specified.

This Action will turn on your devices that support switching on.

This action will run a project saved in your GraspIO Studio account.

This Action will turn off your devices that support switching off.

This action will display text on the OLED.

This action will open the shade

This action will turn on the RGB LED with the selected color.

This action will close the shade

This action will alternately display two colors for the selected duration/delay on the LED .

This Action will set the shade to the position you specify.

This action will make the board speak using the interfaced Speaker.

This Action will set intensity to the percentage you specified.

This action will capture a photo or GIF using the interfaced camera.

This Action will set the thermostat to the mode you specified.

This action will control the Servo Motor angle and speed.

This Action will set the thermostat temperature setpoint to the value you specified.

This action will control the Digital Output ports on the board.

This Action will play an audio tune.

This action will beep the buzzer by turning it on and off at the desired frequency.

This action will pause an audio tune.

This action will override the hot water.

This action will exempt hot water.

This Action will run a scene.