This Trigger fires every time a zone has started.

This trigger fires when the system detects a sound camera event.

This Trigger fires every time a zone has stopped.

This trigger fires when the system detects a water leak.

This Trigger fires every time a watering program has started.

This trigger fires when the system detects a motion camera event.

This Trigger fires every time a watering program has stopped.

This trigger fires when the home security device enters Home mode

This Trigger fires every time device disconnects from the remote access service.

This trigger fires when the home security device enters Away mode.

This Trigger fires when device connects to the remote access service.

This trigger fires when the home security device enters Night mode.

This Trigger fires every time a new software update is available.

This trigger fires when the home security device enters Off mode.

This Trigger fires when freeze protect mode is in effect.

This trigger fires when the home security device alarm has been activated

This Trigger fires every time the rain sensor detects rain.

This trigger fires when a Honeywell Homes Outdoor Motion Viewer is activated.

This Trigger fires every time the rain sensor finished to detect rain.

This Trigger fires every time weather did not update for 24h

This Trigger fires every time a new weather update was successfully executed.

This Trigger fires every time a leak was detected by your sprinkler

This Trigger fires every time a reboot has occurred during watering zone or program

This Trigger fires every time an automatic firmware update has occurred.

This Trigger fires every time a snooze has become inactive.

This Trigger fires every time a snooze has become active.

This query returns a list of when the home security device entered Night mode.

This query returns a list of when the rain sensor detects rain.

This query returns a list of when a Honeywell Homes Outdoor Motion Viewer was activated.

This query returns a list of when the watering program started.

This query returns a list of when the home security device enters Away mode.

This query returns a list of when device connected to the remote access service.

This query returns a list of when the home security device entered Home mode.

This query returns a list of every time a new software update is available.

This query returns a list of when the system detected a motion camera event.

This Action will start watering a specific zone for a certain period of time.

This Action will set your Honeywell thermostat to permanently hold the specified temperature until you change it.

This Action will run a specific watering program.

This Action will set the Honeywell thermostat fan to On where the fan is always on or Auto where the fan runs only when the heating or cooling system is on.

This action will schedule a program to start in the next minute. The difference between scheduling a program to start and just starting a program is that scheduled program will take weather into account whereas a started program will always water 100% of the set duration

This action will arm my Honeywell Home Smart Home Security in Night or Away Mode.

This Action will cancel all running watering events.

This action will let you select one of your sensors to prioritize, so that your T9 or T10 Smart Thermostat senses the temperature from that room.

This Action will skip all watering events for a certain period of time.

This action will set my Z-Wave light or outlet on or off, and control brightness (if available).

This Action will enable a specific program

This action will set a heat or cool setpoint temperature for my thermostat.

This Action will disable a specific program

This will set your T9 or T10 Smart Thermostat room priority to ‘active.’ Active Rooms lets your thermostat detect motion in the rooms that people are in, using your smart room sensors.

This action will change the start time for a specific program.

This action will resume all watering and require beta firmware.

This Action will pause all running watering events and require beta firmware.

This action will save weather data. Make sure you have enabled Local Weather Push from Weather > Developer > Local Weather Push. The units for the data should be metric units.

This action will change the stop time for a specific program.