Connect Nefit Easy to RainMachine and unlock powerful automations

This Trigger fires every time a zone has started.

This trigger fires every time the room temperature changes by a pre-selected amount.

This Trigger fires every time a zone has stopped.

This trigger fires whenever a notification is created by your heating system. This could be a low pressure warning or error message.

This Trigger fires every time a watering program has started.

This Trigger fires when your local room temperature drops below a given threshold.

This Trigger fires every time a watering program has stopped.

This Trigger fires when your local room temperature exceeds a given threshold.

This Trigger fires every time device disconnects from the remote access service.

This Trigger fires when device connects to the remote access service.

This Trigger fires every time a new software update is available.

This Trigger fires when freeze protect mode is in effect.

This Trigger fires every time the rain sensor detects rain.

This Trigger fires every time the rain sensor finished to detect rain.

This Trigger fires every time weather did not update for 24h

This Trigger fires every time a new weather update was successfully executed.

This Trigger fires every time a leak was detected by your sprinkler

This Trigger fires every time a reboot has occurred during watering zone or program

This Trigger fires every time an automatic firmware update has occurred.

This Trigger fires every time a snooze has become inactive.

This Trigger fires every time a snooze has become active.

This query returns a list of when the rain sensor detects rain.

This query returns a list of when the room temperature changes by a pre-selected amount.

This query returns a list of when the watering program started.

This query returns a list of when device connected to the remote access service.

This query returns a list of every time a new software update is available.

This Action will start watering a specific zone for a certain period of time.

This Action will increase the room temperature by a configurable amount.

This Action will run a specific watering program.

This Action will decrease the room temperature by a configurable amount.

This action will schedule a program to start in the next minute. The difference between scheduling a program to start and just starting a program is that scheduled program will take weather into account whereas a started program will always water 100% of the set duration

This Action will set the current room temperature to a level of your choice. This temperature level can be adjusted manually or if Clock Mode is activated.

This Action will cancel all running watering events.

This Action will set your Nefit Easy to auto mode. The auto mode (e.g. clock mode, holiday mode) sets the temperatures accordingly.

This Action will skip all watering events for a certain period of time.

This Action will set your Nefit Easy to manual mode.

This Action will enable a specific program

This Action will set your room temperature to a new set point for a configurable period.

This Action will disable a specific program

This action will change the start time for a specific program.

This action will resume all watering and require beta firmware.

This Action will pause all running watering events and require beta firmware.

This action will save weather data. Make sure you have enabled Local Weather Push from Weather > Developer > Local Weather Push. The units for the data should be metric units.

This action will change the stop time for a specific program.