Change the light to blue if a water leak is detected
Start today
Other popular Aquanta workflows and automations
-
- Alexa Boost my Aquanta
75 - Change the light to red when your water heater exceeds its energy use threshold
- Switch my Aquanta to Away when more than __ kWh of energy is used in a day
- Receive a message when my Aquanta goes offline 7
- Log the time at which my daily energy budget is exceeded 4
- Boost my Aquanta when entering an area 3
- Set Aquanta to away during SmartHours critical price events
1 - Send an SMS when my Aquanta detects hot water use 4
Useful Aquanta and BlueLink Smart Connect integrations
Triggers (If this)
System Mode ChangeThis trigger fires when the system mode changes- Your device has disconnectedThis trigger fires when your device goes offline, meaning it is no longer able to reach the cloud.
- Room Temperature Drops BelowThis trigger fires when the temperature in the room drops below the chosen temperature
- Your device has connectedThis trigger fires when your device comes online and successfully connects to the cloud.
- Room Temperature Rises AboveThis trigger fires when the temperature in the room rise above the chosen temperature
- A leak was detectedThis trigger fires when a leak is detected by the specified device.
- Room Humidity Drops BelowThis trigger fires when the humidity in the room drops below the specified percentage
- Your water heater has exceeded its energy use thresholdThis trigger fires when your water heater exceeds its energy use threshold.
- Room Humidity Rises AboveThis trigger fires when the humidity in the room rises above the specified percentage
- Fan Mode ChangeThis trigger fires when fan mode is changed to the specified value
- Hold Status ChangeThis trigger fires when the hold status of the device is changed to the specified value
- Set Temperature Changes To Above XThis trigger fires when you set the setpoint of either heat or cool to a temperature above a threshold specified by you
- Set Temperature Changes To Below XThis trigger fires when you set the setpoint of either heat or cool to a temperature below a threshold specified by you
- Low Remote Sensor BatteryThis trigger fires when the remote sensor battery is low
- Low Thermostat BatteryThis trigger fires when the thermostat battery is low
- Check WarningThis trigger fires when the check warning activates
- UV WarningThis trigger fires when the UV warning activates
- HUMID PADS WarningThis trigger fires when the HUMID PADS warning activates
- Filter WarningThis trigger fires when the filter warning activates
Queries (With)
Actions (Then that)
- Change Room TemperatureThis action will change the current room temperature. Will either HEAT or COOL, based on what temperature is the thermostat is showing.
- Set AwayThis action will set your Aquanta into Away mode.
- Change Cool SetpointThis action will change the current cool setpoint of the selected device.
- Cancel AwayThis action will cancel an existing Away.
- Change Heat SetpointThis action will change the current heat setpoint of the selected device.
- Set BoostThis action will Boost the specified device.
- Change Hold StatusThis action will change the current hold status of the device (either ENABLED or DISABLED)
- Cancel BoostThis action will disable any running boost action.
- Change System ModeThis action will change the current running mode of the device
- Change Fan ModeThis action will change the current fan mode of the device
- Change Hold ModeThis action will change the current hold mode of the device
IFTTT helps all your apps and devices work better together